3M HIP Grade Class1 Rear marker Plate Reflective Aluminium Plate- 300*300mm

Description

The overall design is made of high brightness lattice reflective material, with a yellow background and prominent red identification areas. The honeycomb shaped reflective texture on the surface can reflect distant incident light back to the light source in low visibility environments such as night, rain, and fog, greatly improving the vehicle’s long-distance recognition.
The label is printed with clear warning text “DO NOT OVERTAKE TURNING VELLE”, which is specifically used to remind rear vehicles to pay attention to the large vehicle ahead turning, predict the risk of internal wheel difference in advance, and avoid collision accidents caused by forced overtaking when a large vehicle is turning.
Equipped with strong adhesive backing, it has excellent waterproof and weather resistance. Even when used in complex outdoor road conditions for a long time, there will be no problem of logo fading or adhesive peeling off. It is fully suitable for side and rear installation scenarios of large vehicles such as trucks and trailers.
 Usage
Preprocessing: After selecting the corresponding installation position on the left side of the vehicle, use a cleaning agent to completely wipe off the oil and dust on the surface of the vehicle body in that area, wait for the surface to completely dry, and avoid residual impurities affecting the adhesion firmness.
Positioning and pasting: After aligning with the preset position, slowly tear off the adhesive backing paper of the reflective sticker, gradually press and paste it from the center of the sticker to the surrounding areas, and use a scraper or hard card to gently scrape off any remaining bubbles under the sticker, ensuring that the sticker is completely tightly attached to the car body without wrinkles or hollows.
Compliance verification: Confirm that the installation position of the sticker will not obstruct the signal devices such as turn signals and taillights of the vehicle, and that the height of the sticker above the ground is not less than 380mm, which meets the relevant specifications for the installation of road vehicle signs.
Daily maintenance: Regularly clean the stains on the surface of the stickers, check if there are any curled edges on the edges of the stickers, and replace them promptly if the reflective layer is worn or the markings are blurred, always ensuring the visual effect of the warning signs.