10g (4.80mm) x 16mm Pan Phillips (PH2) Self Tapping Screw Zinc Plated

Description

Product Introduction
This 10g (4.80mm) × 16mm PH2 cross pan head galvanized self tapping screw produced by VANGUARD INDUSTRIAL is a highly adaptable short carbon steel self tapping fastener:
Core parameters: nominal diameter of 4.8mm, screw length of 16mm, adopting PH2 standard cross groove disc head design, compatible with conventional No.2 cross screwdriver bit, and can be disassembled without special tools.
Process characteristics: The overall galvanizing and passivation treatment can effectively isolate water vapor, with excellent rust and corrosion resistance, and can be adapted to ordinary humid and conventional outdoor working environments; The screw has undergone hardening heat treatment, and the surface hardness of the thread meets the standard. The self tapping structure with pointed and wide teeth can directly tap the corresponding internal thread on the compatible substrate without the need for pre tapping.
Its small and compact size is very suitable for fastening thin boards, small plastic parts, and lightweight wood. It is widely used in small household appliance assembly, furniture accessory fixation, decoration small component installation, and other scenarios. It can be directly fastened without the need for nuts, making construction convenient and efficient.
🛠️ Usage
Preparation in advance
Confirm that the substrate to be tightened is compatible with this 4.8mm self tapping screw, and prepare a PH2 standard Phillips screwdriver, electric screwdriver, or wind screwdriver. Check the screw threads in advance for defects such as burrs, deformation, and coating detachment; When working on hard thick wood or thick metal substrates, it is recommended to drill a guide bottom hole slightly smaller than the screw diameter in advance to avoid substrate cracking or screw breakage when screwing in.
Installation operation
Align the tip and tail of the screw with the pre positioned installation point, keep the screw perpendicular to the surface of the substrate, and use a tool to apply uniform force to screw the screw into the substrate until the disc head is completely attached to the surface of the workpiece, completing the fastening.
Precautions
It is not recommended to use a high torque high-speed electric screwdriver for locking to avoid excessive torque causing the screw head to slip and the substrate to crack; If screws slip or deform during installation, they must be replaced with new screws and reinstalled. Damaged screws cannot be reused.